€8.45
copy of Back Frame Rail in 8 mm + Power Corner
The Artiteq Back Frame Hanging System Rail is a hanging system designed for suspending panels made of aluminum (Dibond), Forex, acrylic, or plexiglass. This system allows the panels to be suspended in a floating and invisible manner.
Product customization
Don't forget to save your customization in order to add it to your cart.
Description
The Back Frame Hanging System is a fixing system specifically designed for thin and flexible panels made of aluminum (Dibond), Forex, acrylic, or Plexiglas. This system allows for invisible (floating) suspension.
The Artiteq Back Frame Hanging System simplifies and secures the installation of printed panels, while reinforcing their structure by distributing the force across all four sides of the rail. The frames are attached to l back of the wall panel and are therefore invisible from the front.
The Back Frame Hanging System is available with an 8 or 15 mm profile and the following finishes: natural aluminum and anodized silver.
This product includes only the rail, which has a total length of 300 cm . To use l , you will need to make a miter cut with a m and apply 3M adhesive tape. Prefer a ready- l use suspension rail? Check out our kits: the 3M adhesive tape is already applied, and the rail is custom-made by professionals in various lengths.
Finally, to use the Artiteq rear frame suspension system, the reinforced corners of the rear frame must be installed. The panel is suspended from the corners of the rear frame; no additional accessories are required.
Tip: When attaching the rear frame suspension system, Artiteq recommends placing the profiles 100 mm from each side of the printed panel.
The use of the rear frame suspension system is recommended when the panel to be hung meets the specified dimensions (see table).
Détails du produit
Delivery
1 other product in the same category:
Reviews (0)